Step Two - Bevel Adjustments - RIDGID MS1060 Owner's Manual

b. With the unit securely resting on a
large stable surface, tilt the unit by
lifting up on one side or the other of
the base. Using allen wrench sup-
plied, loosen the two miter index
spring cap head screws on the
underside of the turn table.
c. Return the saw to its normal resting
position. Make sure the miter lock
knob is loose but do not release the
index spring.
d. Use the miter saw knob to move the
table so that the blade contacts the
full length of the square. Watch out
for tooth set. Turn the miter lock
knob clockwise to lock saw square to
fence.
e. Tilt saw as in Step b and tighten cap
head screws.
f. Recheck blade squareness to fence
and readjust if necessary.
WARNING: To reduce the risk of
injury from unexpected starting
or electrical shock, do not plug
the saw in. The power cord must
remain unplugged
you are working on the saw.

Step Two - Bevel Adjustments

Bevel Stop Adjustments
NOTE: The miter saw was assembled,
aligned, and inspected before shipment.
Alignment should be checked and any
adjustments made to insure accurate
cuts.
1. Check miter lock knob setting. The
miter lock knob should be at the 0°
position. To reset the miter angle, turn
the miter lock knob counter clockwise
and press down the index spring.
2. Lower the power head and lock the
stop shaft. Make sure the bevel index
pin is pushed in. Loosen the bevel lock
knob and tilt powerhead until it con-
tacts the 45° stop.
Adjustment of Miter Scale Indicator
1. Loosen the phillips screw that holds the
2. Reposition the indicator and retighten
3. Using the square, check for accuracy of
whenever
Bevel Pivot
Adjustment
(Recessed)
17
indicator in place.
screw.
Miter Index Spring
Cap Head Screws
the 45° stop (when the blade makes
contact with the full length of the
square). Do not measure across the set
of a blade tooth. Repeat this for 0°
bevel. If either stop is inaccurate, follow
the alignment procedures: a. through g.
Screw