Sawdust; Lubrication; Ridgid Recommends The Following Accessories; Recommended Accessories - RIDGID MS1060 Owner's Manual

Maintenance and Lubrication (continued)

Sawdust

Periodically, sawdust will accumulate
under the work table and base. This could
cause difficulty in the movement of the
work table when setting up a miter cut.
Frequently blow out or vacuum up the
sawdust.
WARNING: If blowing sawdust,
wear proper eye protection to
keep debris from blowing into
eyes.

Lubrication

All the motor bearings in this tool are lubri-
cated with a sufficient amount of high
grade lubricant for the life of the unit
under normal operating conditions. There-
fore, no further lubrication is required.
Infrequent Lubrication as Required:
1. Lubrication of arm pivot for free move-
ment.
a. Apply oil between washer and con-
tact face of Table/Pivot casting.
b. Apply oil to pivot shaft next to inside
surface of ears on arm casting.
NOTE: Disassembly should be done by
an authorized service technician.
Removal of the upper guard and the stop-
shaft is necessary before pivot can be dis-
assembled. Pay close attention to the
spring-end positions in the cast-

RIDGID Recommends the Following Accessories

Recommended Accessories

Item
Clamp Kit ..................................... AC3000
Legset .......................................... AC9910
Do not use any accessory unless you
have received and read complete instruc-
tions for its use.
WARNING: To reduce the risk of
injury from unsafe accessories,
use only accessories supplied.
ings...mark with chalk to avoid later con-
fusion.
2. Lubrication of mechanism which pivots
lower guard (see illustration): Use light
household oil (sewing machine oil) or a
pressurized light spray oil on metal-to-
metal or metal-to-plastic guard contact
areas as required for smooth, quiet
operation. Avoid excess oil, to which
sawdust will cling. Lubricate the lower
guard spacer, roller, pivot plate and link
pivot.
3. Lubrication of miter index indents: Use
a small amount of grease on the miter
index indents that are located below
the table on the front of the unit.
Link
Pivot

Prohibited Accessories

SKU No. The use of any cutting tool except 10"
saw blades which meet the basic blade
requirements is prohibited. Do not use
accessories such as shaper cutters or
dado sets. Cutting ferrous metal (metal
with iron in it) and the use of abrasive
wheels are prohibited. See WARNING
and CAUTION notes in the "Safety
Instructions For Basic Saw Operations"
Section. If planning to saw non-ferrous
metal see those WARNING and CAU-
TION notes in the "Safety Instructions For
Basic Saw Operations" Section.
32
Lower Guard
Spacer
Roller
Miter Index
Indents (7)
Pivot
Plate