Advertisement
Hardware Bag Contents (Figure 4 and Table Below)
ITEM#
PART#
1
090-0502
5/16 FENDER WASHER
2
805-0326
CARABINEERS
3
4
805-0119
BAG HANGER HOOKS
5/16-18 X 1" HHCS
5
090-0088
6
090-0418
5/16-18 WHIZ LOCKNUT
7
090-0460
5/16-18 NYLOCK NUT
8
090-0232
5/16 FLAT WASHER
9
090-0503
5/16-18 SELF TAPPING HHCS
Compare the contents of the Shipping Box, Poly Bag and
Hardware Bag with the "Contents" lists above. If you
have any questions please contact us at
www.MacKissic.com or call 1-800-348-1117 for
assistance.
NOTE: Assembly should be done on a clean, level surface.
DO NOT try to lift the machine out of the box, it is very
heavy and may cause severe injury.
2. Use the utility knife to cut down the two corners one
end of the Box, and then roll the machine out (Figure
5).
Assembling the Multi-Surface Vacuum
Tools Needed:
•
5/16" Wrench
•
Two 1/2" Wrenches
•
Two 7/16" Wrenches
1. Position the two Lower Bag Hanger Frames onto the
cross member of the Lower Handle and loosely install
with two 5/16-18 x 1" Bolts and two 5/16- 18 Nylon
Locknuts using two 1/2" Wrenches (Figure 6).
2. Position the Upper Bag Hanger Frame onto the two
Lower Bag Hanger Sides with the top holes facing
closer to the rear of the machine. Secure the lower two
sets of holes in the Upper Bag Hanger Frame to the
Lower Bag Hanger Frames with four 5/16-18 x 1" Bolts
and four 5/16-18 Nylon Locknuts using two 1/2"
Wrenches. Tighten the Hardware you installed in the
previous step.
3. Take the Upper Handle Bar Assembly and slide the flat
ends of the Upper Handle inside the Lower Handle.
Secure with four 5/16- 18 x 1" Bolts and four 5/16-18
Nylon Locknuts (Figure 7).
DESCRIPTION
3
QTY
6
2
2
3
10
3
1
14
2
4
Figure 4
Figure 5
Lower
Bag
Hanger
Frame
CONTACT US AT www.MacKissic.com
4
6
8
5
VMS
Machin
e
Upper Bag
Bolts and
Hanger Frame
Locknuts
Figure 6
Bolts and
Locknuts
9
7
9
Advertisement
