Advertisement
Chapter 6: Troubleshooting
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems and their solutions. If you
continue to experience problems, contact us at www.MacKissic.com or call toll-free 1-800-348-1117 for support.
Shut down the engine, remove the spark plug wire and wait 5 minutes for parts to cool before performing any maintenance
procedure or inspection on the Machine.
Troubleshooting Table
S
YMPTOM
Engine fails to start
Loss of power, operation
erratic
Engine overheats
Unit does not discharge Discharge tube clogged; Stop engine immediately and disconnect spark plug wire. Clean inside
Excessive vibration.
Loss of vacuum
P
C
; C
OSSIBLE
AUSE
ORRECTIVE
Fuel tank empty; Fill tank with clean, fresh fuel.
Spark plug wire disconnected; Connect wire to spark plug.
Faulty spark plug; Clean, adjust gap or replace the spark plug.
Spark plug wire loose; Connect and tighten spark plug wire.
Running on "CHOKE"; Move choke lever to "RUN" position.
Blocked fuel line or stale fuel; Clean fuel line; fill tank with clean, fresh gasoline.
Water or dirt in fuel system; Disconnect fuel line at carburetor to drain fuel tank.
Carburetor out of adjustment; contact us at www.MacKissic.com or call 1-800-348-1111
for assistance.
Dirty air cleaner; Clean or replace air filter.
Carburetor not adjusted properly; contact us at www.MacKissic.com or call 1-800-348-1117
for assistance.
Engine oil level low; Fill crankcase with proper oil.
Internal engine cooling fan not working properly due to debris buildup over engine crank cover;
Clean debris away from engine crank cover for improved air circulation.
of blower housing. See "MAINTENANCE" section of this manual.
Foreign object lodged in impeller; Stop engine immediately and disconnect spark plug wire.
Remove lodged object.
Loose parts or damaged impeller assembly; Stop engine immediately and disconnect spark plug
wire. Tighten all bolts & nuts. Make all necessary repairs. If vibration continues, contact us at
www.MacKissic.com or call 1-800-348-1117 for assistance.
Vacuum snout clogged; Remove & clean.
Collection bag full; Remove & empty bag.
Discharge tube clogged; Remove collection bag & clean tube.
Processing chamber clogged; Remove vacuum snout to clean chamber.
Engine not reaching full RPM; contact us at www.MacKissic.com or call 1-800-348-1117
for assistance.
Fan blades bent or broken; Replace rotor.
A
CTION
CONTACT US AT www.MacKissic.com
21
Advertisement
