Advertisement
4. Locate the two Carabiners, three Bag Hanger Hooks
and four 5/16-18 Wiz Nuts included in the Bolt Bag.
Mount the two upper Hooks through the upper holes
in the Handlebar Assembly with the Hooks on the
inside (Figure 8). Secure with a Wiz Nut on the outside
of the Upper Handlebar.
5. Thread a Wiz Nut onto the one remaining Hook as far
as it will go on the threads so that the flat side of the
Nut is facing away from the Hook (See detail).
6. Insert the Hook into the right side of the Bag Hanger
Frame and secure with a Wiz Nut.
7. Install the two Carabiners onto the Bag Hanger Frame
with wider side down and clip facing the rear of the
machine.
8. Place the Discharge Tube on top of the Housing (Figure
9). Be sure the discharge opening is directed to the rear
of the machine and between the Handles. Secure the
Tube to the front of the Housing with two 5/16"-18 x 3/4"
Self-Tapping Bolts and two 5/16 Fender Washers.
9. Secure the Tube and two Safety Wire Harness Cable
Clamps to the rear of
the Housing with two 5/16"-18 x 5/8" Bolts and Flat Washers (not fender
washers) (Figure 10).
10. Connect the Safety Harness onto the Terminals of the Bag Safety Switch
(Figure 11) and secure the Cable Clamp to the hole in the side of the
Discharge Tube with the Self Tapping Screw using a 5/16" Wrench.
Figure 9
Bolt
and
Fender
Washer
Dis
charg
e
Tube
Housin
g
Discharge Tube
Safety Switch
d
Harness
t Washer
10
MULTI-SURFACE VACUUM
Bolt
an
Figure 10
Fla
Cable
Clamp
s
Lower
Bolts and
Handlebar
Locknuts
Upper
Handlebar
Carabiner
Safety Switch
Discharge
Harness
Tube
Cable
Clamp
Safety Switch
Terminals
Upper Handlebar
Figure 7
Bag Hanger Hook
With Wiz nut
Figure 8
Bag
Hanger
Hook
with
Two Wiz
nuts
Screw
Figure 11
Advertisement
