Applying Coax Seal Tape; Installation Of Ap 2330A/2330B; Installation Of The Nema Enclosure - Nortel 2330 Solution Manual

WLAN 2300 Series Outdoor Solution with AP Mounted in NEMA Enclosure 61
Grounding principles
To connect the Surge Protector to ground, use the shortest and most direct run possible with #8 solid copper
wire (or equivalent).
Refer to your local electric code standards for correct installation.

Applying coax seal tape

For applying Coax seal tape refer:
See "Coax cable seal installation" page 52

Installation of AP 2330A/2330B

In this section you will find instructions on installing the AP 2330A/2330B in an outdoor mounted enclosure.

Installation of the NEMA Enclosure

1
Remove the NEMA Enclosure from the ODS kit and place it on a flat surface near the installation
location. The following figure shows the enclosure connections from left to right: ground lug, Ethernet
Gland, and two external antenna connectors.
Figure 12. NEMA Enclosure
2
Open the enclosure cover by pushing the latches down on the side and lifting the cover up.
Nortel WLAN 2300 Series Outdoor Solution Guide