Advertisement
SERIES 569 SELF PROPELLED
2.5.
Loosen the belt guide with a pair of 7/16"
wrenches. See Figure 2.5.
Holes for
tabs on belt cover.
Figure 2.5
NOTE: The belt guide dose not need to be
removed simply loosen enough to allow the belt
to clear the pulley.
NOTE: Notice the holes on each of the wheel
brackets designed to stabilize the belt cover.
2.6.
Slip the belt off of the transmission pulley.
See Figure 2.6.
Figure 2.6
2.7.
2.8.
Belt Guide
2.9.
2
Position the mower on its left side to keep the air
cleaner and carburetor elevated.
NOTE: Due to the orientation of the vent on the
transmission positioning the mower on its left
side is also advisable
Pull the belt in towards the rear of mower deck.
See Figure 2.8.
Figure 2.8
Remove the old belt from the crank shaft this
can be done with the blade still on the machine.
See Figure 2.9.
Figure 2.9
NOTE: It may be necessary to spin the blade to
allow the belt to fit between the blade tip and the
deck.
Advertisement
