3) Using the coil of 3/8" BLACK tubing provided with the Parts Packet, connect one end to the 3/8" barb connection, found at
the bottom of the air gap faucet. Ensure connection is secure.
4) Locate the Drain Saddle Clamp (installed in a previous step) and unscrew the attached compression nut.
5) Slip the compression nut over the second end of the 3/8" BLACK tubing – making sure threads are facing the correct
direction.
6) Find the 3/8" tube insert that was enclosed with the Parts Packet. Place this insert inside the second end of the 3/8" BLACK
tubing.
7) Push the 3/8" BLACK tubing with insert into the Drain Saddle Clamp and tighten with wrench until tight. Ensure connection
is secure.
NOTE: When connecting the drain tubing, make a downward slope from the RO System to the drain saddle to allow for proper
drainage. Avoid bending or kinking the drain tubing.
For a Standard Non-Air Gap Faucet
1) At this point, one end of the provided 1/4" BLACK tubing should be connected to the Drain/Reject Outlet on your RO
System, with the desired Drain Flow Restrictor installed.
2) Locate the Drain Saddle Clamp (installed in a previous step) and unscrew the attached compression nut.
3) Slip the compression nut over the second end of the 1/4" BLACK tubing – making sure threads are facing the correct
direction.
4) Find the 1/4" tube insert that was enclosed with the Parts Packet. Place this insert inside the second end of the 1/4" BLACK
tubing.
5) Push the 1/4" BLACK tubing with insert into the Drain Saddle Clamp and tighten with wrench until tight. Ensure connection
is secure.
NOTE: When connecting the drain tubing, make a downward slope from the RO System to the drain to allow for proper drainage.
Avoid bending or kinking the drain tubing.
19