Site Preparation; Advisory; Intended Use; Siting The Product - Delta Membranes Battery Backup Installation Manual

Table of Contents

Advertisement

3. Site preparation
3.1

Advisory

All products are manufactured and developed to the highest standards and assembled with precision and care. Each product has
been rigorously tested. We constantly strive to develop our products to provide you with the most innovative products possible.
Please read these installation and operating guidelines carefully prior to installation. These guidelines contain important
information and hazard warnings, which will enable you to install and operate your product safely, economically, and reliably.
Only qualified personnel should carry out the installation in accordance with the latest IET wiring regulations BS7671. All works
should be in line with the Health and Safety at Works Act 1974.
It is important to note that these guidelines are for guidance only and it is the installer's responsibility to satisfy themselves that
the installation procedure is in accordance with good practice, this will then eliminate any potential damage to the product during
or after installation.
If you are unsure on any point, then please contact Delta Membranes on 01992 523 523 between 8am and 5pm, Monday to Friday
or by email at info@deltamembranes.com for more information.
3.2

Intended use

Delta Battery Backup is designed for use indoor use only. Under no circumstances should the product be installed outdoors.
Do not operate the Delta Battery Backup in direct sunlight, in contact with fluids, or where there is excessive dust or humidity.
Allow adequate space for proper ventilation.
The output power can be set by selecting the inverter size. In choosing this, it is advisable to exceed the rated power of the pump
by 30%. For example if the pump is 500 W, set the output power to 750 W.
3.3

Siting the product

Select a suitable location for the Delta Battery Backup, taking into account cable lengths from the base of the pump chamber/
sump, through the cable duct to the panel. If you need to mount the panel further away from the pump chamber/sump, please
contact Delta Membranes on 01992 523 523 between 8am and 5pm, Monday to Friday or by email at info@deltamembranes.
com for more information.
Install the equipment in a dry and well-ventilated place and accessible by the end user and service engineers.
It must be located where the panel's alarm is audible. Please consider the Noise Pollution Act.
The equipment should be fixed to the wall a minimum of 500 mm above FFL. The battery holder(s) must to be fixed to the Delta
Battery Backup enclosure as well as to the wall.
2. Site preparation and installation
01992 523 523 info@deltamembranes.com www.deltamembranes.com
6

Advertisement

Table of Contents
loading

Related Products for Delta Membranes Battery Backup

Table of Contents