Additional Information - Electrolux WP71-265WT User Manual

18 www.electrolux.com
set to Fan mode. Then, set
temperature to a higher setting.
haust duct not connected or bloc ed
See 5.1 Exhausting hot air Section.
Air conditioner cooling, but room
is too warm - ice forming on cooling
coil behind decorative front.
irt air lter air restricted
lter
section.
Temperature is set too high. Set
temperature to a lower setting.
Air directional louvers positioned
improperly. Position louvers for
better air distribution
ront o unit is bloc ed b dra es
blinds urniture etc
distribution
of unit.

10. ADDITIONAL INFORMATION

Transport of equipment containing
flammable refrigerants
See transport regulations.
Marking of equipment using signs
See local regulations.
Disposal of equipment using
flammable refrigerants
See national regulations.
Storage of equipment/appliances
he storage o e ui ment should be
in accordance with the manufacturer's
instructions.
Storage of packed (unsold) equipment
torage ac age rotection should be
constructed such that mechanical damage
to the equipment inside the package will
not cause a leak of the refrigerant charge.
he ma imum number o
e ui ment ermitted to be stored together
ill be determined b local regulations
Information on servicing
1. hec s to the area Prior to beginning
or on s stems containing ammable
refrigerants, safety checks are
necessary to ensure that the risk of
ignition is minimised. For repair to
e er to are and leaning
restricts air
lear bloc age in ront
ieces o
Doors, windows, registers, etc. open -
cool air escapes. Close doors,
windows, registers, etc.
Unit recently turned on in hot room.
Allow additional time to remove "stored
heat rom alls ceiling
furniture.
Air conditioner turns on and off
lean air
rapidly.
irt air lter air restricted
lter
Outside temperature extremely hot. Set
through cooling coils more frequently.
Room too cold.
Set temperature too low. Increase set
temperature.
the refrigerating system, the following
recautions shall be com lied ith
prior to conducting work on the
system.
2. or
undertaken under a controlled
procedure so as to minimise the
ris o a ammable gas or a our
being resent hile the or is being
performed.
3. General work area. All maintenance
sta and others or ing in the local
area shall be instructed on the nature
o
con ned s aces shall be a oided
The area around the workspace shall
be sectioned o
conditions ithin the area ha e been
made sa e b control o
material.
4. Checking for presence of refrigerant.
he area shall be chec ed ith an
appropriate refrigerant detector prior
to and during work, to ensure the
technician is aware of potentially
ammable atmos heres
the lea detection e ui ment being
used is suitable or use ith ammable
refrigerants, i.e. nonsparking,
adequately sealed or intrinsically safe.
s eed to a aster setting to bring air
rocedure or shall be
or being carried out
nsure that the
oor and
lean air
or in
ammable
nsure that