Table of Contents
Advertisement
Available languages
Available languages
Dry mode
In this mode you do not need to use the
exhaust adaptor hose, BUT the water
collected must be discharged
Drainage Section.
1. Press the
odes button until the
indicator is lit.
2. The fan will run at low speed and the
display will show the room temperature.
3. Kee doors
indo s closed or best
e ect
4. Connected drain hose. See Drainage
section.
Auto mode
Always have the exhaust hose attached
in this mode.
When you set the air conditioner in Auto
mode, it will automatically select cooling,
heating ina
licable or cooling onl
models or an onl o eration de ending
on what temperature you have selected
and the room temperature. The air
conditioner will control room temperature
automatically round the temperature
oint set b
ou
Under AUTO mode, you can not select
the fan speed.
Press the
odes button until the
"Auto mode" indicator lights.
After the "Auto mode" is selected the unit
will run automatically according to the
actual room air temperature.
hec
lter eature
1.
leaning the lter
2. Press and hold the
seconds to turn o the lter indicator
Selecting fan speed
ou can select the desired an s eed b
ressing the
an s eed button
s eed ill change in the se uence
Fan", "High", "Mid", "Low".
After choosing the fan speed as
"Auto Fan", "High", "Mid" or "Low",
the corresponding fan speed
indicator light will illuminate.
Under Auto and Dry mode,
you can not select the fan speed.
ee
r
lter button or
he an
uto
he i module can be deacti ated b
holding the
onnect button and
"synchronously 3 seconds. Press the
onnect button again to acti ate the i
module again t ill ta e about
for the module to initiate again.
7.2 Fault code
If the display reads "A5", the room
temperature sensor has failed. Contact
your Authorized Electrolux Service Centre.
If the display reads "E5", the evaporator
temperature sensor has failed. Contact
your Authorized Electrolux Service Centre.
If the display reads "E4", the display panel
communication has failed. Contact your
Authorized Electrolux Service Centre.
the dis la reads P
is full. Carefully move the unit to a drain
location remo e the bottom drain lug
and let the water drain away. Restart the
machine until the P
If error repeats, call for service.
If the display reads "E7", the indoor motor
has failed. Contact your Authorized
Electrolux Service Center.
ENGLISH
15
seconds
bottom tra
s mbol disa
ears
Advertisement
Table of Contents
