IBM Power E1050 Manual page 20

Figure 1. Removing an NVMe U.2 drive
c) Place the drive on an ESD mat.
3. If you are using the AIX
and press Enter. Both the green and amber LED are turned off.
A message that the remove operation is complete is shown.
Removing an adapter from the 9043-MRX system
To remove an adapter from the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Remove the cassette from the slot:
a) Squeeze the latch lever of the cassette and press down on the latch.
This action pivots the cassette latch forwards, releases the cassette from the slot, and slightly
slides the cassette out from the system..
b) Hold onto the latch lever and by using your hand to support the bottom of the cassette, pull out the
cassette from its slot.
6 Power Systems: Installing the IBM Power E1050 (9043-MRX)
®
operating system, after you remove the NVMe U.2 drive, return to the console