Table of Contents
Advertisement
MBS-1P Installation
®
Installation of Electrical System
Power and Sensor Cables
One power cable, and two or four sensor connector cables are integrated into
the MBS-1P. The power cable runs to the Weather Pack 5-way connector on
the trailer. The sensor cables terminate in molded two-pin (industry standard)
connectors.
MBS-1P Cable Options
The MBS-1P can be configured with either a long or short power cable. Refer
to the system component charts on page 3 and 4 for specific system and part
number information.
The short power cable is typically used with fixed bogies.
The long power cable is typically used with sliding bogies. Route the power
cable with the slider hoses to the trailer frame.
NOTE: The long cable can also be used on fixed bogies if required.
MBS-1P with short power cable (WNC part number 10800262).
14
Advertisement
Table of Contents
