Vertiv™ Netsure™ Control Unit (Ncu) Controller 2Nd Ethernet Port Retrofit Kit; Kit Description - Vertiv NetSure Installation Manual

2nd ethernet port add-on kit

Hide thumbs Also See for NetSure:

Table of Contents

Vertiv™ NetSure™ Control Unit (NCU) Controller 2nd Ethernet Port Add-On Kit Installation Manual

1 Vertiv™ NetSure™ Control Unit (NCU) Controller 2nd

Ethernet Port Retrofit Kit

These instructions provide a step-by-step procedure to field install this kit into Power System Spec. No. 582127000 and 581127000.

Installation of this kit in other equipment should not be attempted.

This kit provides the IB4 board with a second Ethernet port. The Ethernet port located on the NCU Controller's front panel can be

used to connect a computer directly to the NCU. The Ethernet port located on the IB4 board can be used to connect the NCU

Controller to your Local Area Network (LAN).

There are two kits available. One to add the IB4 board to a newer style main bay that provides an NCU Controller motherboard

connector for an IB4 board cable and the other for an older style main bay that does not have this NCU Controller motherboard

connector. THIS KIT IS FOR A MAIN BAY THAT HAS AN IB4 BOARD CONNECTOR LOCATED ON THE NCU MOTHERBOARD. See

Figure 1.1 for identification.

Figure 1.1 Identifying Control Module Assembly IB4 Board Connector

Table of Contents