Qos Show Commands; Show Qos Service-Package Queues - Nortel Versalar 15000 Reference Manual

show qos service-package queues

QoS Show Commands

This section describes the QoS show commands and the command options you
can enter. It also describes the information in the tables the router displays.
show qos service-package queues
The
information about each service package and its associated queues. This command
allows for the following options:
-rule <name>
-package-name <name>
<value>
The output includes the following information:
Service Package
Queue Name
State
Srv Class
Acct Rule
Rx CIR
Rx Burst Rate/Size/Action
Tx DP
Tx Weight/Actual
138
show qos service-package queues
command displays configuration
Displays the service package queues using the
accounting rule you specify.
Displays the queues assigned to the service package you
specify.
Displays the package name.
Service name given to this interface.
Queue name given to this interface.
Current state of this queue. Possible values here are: Up,
Waiting for a Service Package, or Misconfigured .
Class level for this queue, with 0=highest, 7=lowest.
Accounting rule template name.
Committed information rate (CIR), in Kbits per second,
configured for this interface.
Burst rate and burst size configured for this interface and
action to be taken when the burst rate is exceeded.
Possible actions are: none (1), downgrade (2), mark (3),
and mark-downgrade (4).
Hardware threshold in percent to start dropping output
packets for this queue. When set to none, all packets are
accepted until the queue fills to 100 percent. Possible
values are: none (1), percent-83 (2), percent-66 (3), and
percent-50 (4).
Actual weight, in percentage, given to this transmit queue
within its service package when set to round robin
scheduling.
308689-B Rev 00