Maintenance - Waydoo Flyer ONE Quick Start Manual

Waydoo Flyer ONE Quick start guide
1. The motor stops rotating during driving
Please immediately release the trigger of the remote control to stop the motor, turn off
the remote control, and lay on the surfboard and paddle back to the shore with both
hands. First check whether the status indicator of the remote control shows normal
connection status, then check whether the battery level is normal, and then check
whether the powertrain and the board are loose. If it is loose, please tighten it in time.
If the problem is not solved after the above steps are completed, please take out the
battery and check whether the metal joints seep into sea water or corrosion. If the
above situation occurs, please rinse the plug with fresh water and dry it with a rust
remover to remove the rust on the metal joints , And then wash and dry.
2. The machine shakes, vibrates, and is difficult to maintain balance during use
Please immediately release the trigger of the remote control to stop the motor, turn off
the remote control, and lay on the surfboard and paddle back to the shore with both
hands. Take out the battery and check whether the mounting bolts of the power
assembly are loose. If they are loose, please tighten them in time.
3. The remote control connection appears intermittent during use
Please immediately release the trigger of the remote control to stop the motor, turn off
the remote control, and lay on the surfboard and paddle back to the shore with both
hands. Turn on the remote control and check whether the Bluetooth icon is flashing. If
it is flashing, please restart the battery and re-pair the Bluetooth. If the problem is still
not resolved, please contact after-sales service in time.
4. The remote controller has a fault Err. 1: Angle sensor initialization failed Err. 2:
spiflash initialization failed Err. 3: Both 1 and 2 failed to initialize Err. 4: GPS failure
Err.7: 1, 2, 3, 4 all malfunction

Maintenance

。
Regularly check the waterproof components (remote control, battery, Mast head, etc.)
for damage and the status of each module of the power system and control system.
1. After using the product, please turn off the remote control and battery first.
2. To clean the powertrain, align the water inlet of the motor mount with a fresh water
pipe, and clean the motor mount for about 30 seconds to ensure that the motor mount
is clean and free of debris; clean the motor shroud, propeller, and propeller guard;
Clean the Mast plug. If you find salt, sand or other debris, be sure to clean it; clean
the mast.
3. Clean the surfboard, clean the battery mounting position and the Mast mounting
base and other parts with fresh water to ensure that there is no salt, sand or other
debris remaining. Then wipe it with a dry towel and let it sit in a dry environment to dry
13
2020
the remaining water.
1. Clean the battery, clean the battery integrated ports and buttons with fresh water,
then dry it with a dry towel and let it stand in a dry environment to dry the remaining
water.
2. Clean the remote control. Pay special attention to the location of the remote
control trigger. If you find that there is a jam when pulling the trigger, please check
whether there is gravel in the trigger, and rinse the gravel out with clean water.
3. After cleaning, wait for the moisture of all parts to dry before putting the parts back
into the package.
4. When storing this product, avoid direct sunlight, because ultraviolet rays and high
temperature will cause permanent damage to the product.
5. Be sure to turn off the remote control and battery when transporting this product to
ensure safety.
Waydoo Flyer ONE – Warranty period
Hydrofoil 1 year
Powertrain 1 year
Front and rear wings 1 year
Smart battery 1 year with less than 300 cycles
Remote control 1 year
Charger 1 year
1.
After-sales service plan
2. 联 系 苇 渡 时 ， 请 您 详 细 说 明 产 品 存 在 的 问 题 。 1. When contacting Weidu, please explain in detail the problem with the product.
2. Weidu's technical support staff will try to diagnose and solve your problem by phone,
3. 苇 渡 的 技 术 支 持 人 员 将 尝 试 通 过 电 话 、 电 子 邮 件 或 远 程 协 助 来 诊 断 和 解 决 您 的 问 题 。
email or remote assistance.
4. 如果通过 上 述 途 径 仍 无 法 解 决 您 的 问 题 ， 请 将 产 品 寄 回 苇 渡 进 行 进 一 步 检 测 。 苇 渡 会 按 产 品 相 应 的 保 修 服 务 类 型 为 您
3. If you still cannot solve your problem through the above-mentioned methods, please
send the product to Weidu for further testing. Weidu will arrange services for you
安排服务 。
according to the corresponding warranty service type of the product
非售后保障范围
Non-after-sale coverage
1). Damage caused by transportation or loading and unloading during the return,
exchange and repair. 2). Any unauthorized modification, disassembly, opening and
repair without official authorization. 3). Battery damage caused by any accidental
factors or human factors, such as obvious hard object damage, cracks, severe
deformation, broken power cord, disconnection, etc. 4). Product failure or damage
caused by installation, use, maintenance, and storage not in accordance with the
requirements of the instruction manual. 5). Due to circuit modification, battery pack
modification or using unmatched chargers guided by unofficial instructions. 6). Damage
caused by using within the safe load range of the product. 7). Damage caused by
forced use of the product when the parts are damaged. 8). Damage caused by using
batteries with quality problems. 9). The product or component with the identification
label changed or removed. 10). Failure or damage caused by force majeure (such as
fire, earthquake, flood, etc.). 11). Products or parts that have exceeded the warranty
period.
Waydoo Flyer ONE Quick start guide
2020 苇 渡 智 能 版权 所有
14