Installing An Sfp - Nortel 8300 Installation Manual

22 Small form factor pluggable transceivers

Installing an SFP

Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about 3 minutes.
Prerequisites
•
Procedure steps
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Verify that the SFP is the correct model for your network configuration.
CAUTION
SFPs are keyed to prevent incorrect insertion. If the SFP resists
pressure, do not force it; turn it over, and reinsert it.
Action
Remove the SFP from its protective packaging.
Grasp the SFP between your thumb and forefinger.
As shown in the following figure, insert the device into the slot on
the module.
Apply a light pressure to the device until it clicks and locks into
position.
Nortel Ethernet Routing Switch 8300
Installation — SFPs and XFPs
NN46200-307 01.02 Standard
4.0 27 August 2007