VTech BM3210 Installation Manual

BM3210 Baby Unit
Installation Guide
(for use with BM3200
parent unit)
Mount the Baby Unit
1
Note: Check for reception strength and camera
angle before drilling the holes.
Place the wall mount bracket on a wall, and then use a
pencil to mark the top two holes as shown. Remove the wall
mount bracket and drill two holes in the wall (7/32" drill bit).
2
I
f you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert
the wall anchors into the holes. Tap gently on the ends with a
hammer until the wall anchors are flush with the wall.
3
Align the wall mount bracket and screws with the holes in the
wall as shown. Tighten the screw in the middle hole first, so
that the wall mount bracket position is fixed. You can tighten
the other screw in the top hole.
4
1
Place the baby unit on the wall mount bracket. Tighten the
screw into the threaded socket at the bottom to secure
the baby unit.
5
Power outlet not controlled
by a wall switch
3
2
2
Bundle the
power cord
1