Table of Contents
Advertisement
en Troubleshooting
Fault
The drying time is too
long.
Water is leaking from
the appliance.
The laundry is too
damp.
38
Cause and troubleshooting
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
Opening the base unit.
1.
→ "Opening the base unit", Page 33.
Cleaning the heat exchanger.
2.
→ "Cleaning the base unit", Page 33.
Closing the base unit.
3.
→ "Closing the base unit", Page 34.
Appliance is not correctly aligned.
→ "Aligning the appliance", Page 13
▶
Unsuitable programme for the type of fabric.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 21
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 21.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
→ "Changing the dryness level", Page 20.
▶
Drying target not adjusted.
→ "Adjusting the dryness level", Page 20.
▶
Load too small.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 21
Moisture sensor dirty.
→ "Cleaning the moisture sensor", Page 35.
▶
The drying process is interrupted and the condensa-
tion tank has been filled.
→ "Emptying the condensation container", Page 27.
1.
→ "Inserting the condensation container", Page 28.
2.
→ "Starting the programme", Page 25.
3.
Advertisement
Table of Contents
