Table of Contents
Advertisement
4.3 Requirements for the in-
stallation location
ATTENTION!
If the appliance is tilted at an angle
greater than 40°, residual water may
leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an up-
▶
right position.
If residual water in the appliance
freezes, this may cause damage to
the appliance.
Do not install or operate this appli-
▶
ance anywhere that is liable to ex-
perience frost or outdoors.
Installation loca-
tion
On the floor
In a washer-dryer
stack
Requirements
Place the appli-
ance on a clean,
level and firm
surface.
Align the appli-
ance
→ Page 13.
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
¡ Connection kit
→ Page 24
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
Installation and connection en
Installation loca-
tion
4.4 Aligning the appliance
In order to reduce vibrations and
noises, align the appliance correctly.
To align the appliance, turn the ap-
▶
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
4.5 Connecting the appliance
to the electricity supply
Insert the mains plug of the appli-
1.
ance's power cable in a socket
nearby.
The connection details of the appli-
ance can be found under Tech-
nical data → Page 42.
Check the mains plug is inserted
2.
properly.
Requirements
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
13
Advertisement
Table of Contents
