General; Document Information; Range; Accessories - Ferroli RCI 35-40 Installation, Maintenance And User Manual

1. General

1.1

Document information

1.2

Range

1.3

Accessories

1.4 Compliance
1.5 Machine identification
1.6 Residual risk
1.7 Intended use
1.8 General precautions
1.9 Basic safety rules
1.10 User guidelines
1.11 Machine description
1.1 Document information
A Chapter
B Sequence of paragraphs
C Preliminary precautions
D Operations
• The manual is divided into chapters as follows:
- General;
- Shipment;
- Installation;
- Water connections;
- Electrical connections:
- Commissioning;
- Control panel;
- Maintenance.
- Attached.
• The preliminary precautions must be read before performing any of the following operations.
This document uses the following definitions:
- Danger zones: any area inside and/or near the machine in which the presence of an
exposed person constitutes a risk to his/her own health and safety.
- Exposed person: any person who is entirely or partially in a danger zone.
- Operator/Maintenance Technician: the person/s assigned to operate, adjust, service, repair
or move the machine.
4
1.1.1 Symbols
• This publication contains the following symbols:
Draws attention to actions that can cause serious injury if not performed
Danger
correctly.
Prohibited Draws attention to actions that impose a prohibition.
1.2 Range
Models with plate evaporator
RCI
RCI
1.2.1 Available versions
RCI R
Cooling only
RCI P
Reversible Heat Pump
1.3 Accessories
Factory fitted accessories
BT Low water temperature kit
TX Coil with pre-coated fins
TXB Coil with epoxy treatment
PS Single circulating pump
FE Antifreeze heater for evaporator
Loose accessories
CR Remote control panel
IS Modbus RTU protocol, RS485 serial interface
RP Coils protection metallic guards
AG Rubber shock absorbers
35
40