General Introduction; Function Description; Installation Guideline; Accessories - Ferroli OMNIA M 3.2 Installation Manual

Hydraulic electronic board box

Operation manual (124 pages)

Installation and owner's manual (96 pages)

Installation and owner's manual (508 pages)

Available languages

HYDRAULIC ELECTRONIC BOARD BOX

2. GENERAL INTRODUCTION

This kit is used to shorten the field connection cable length between hydraulic module PCB and TBH, external electric heater, AHS, SV1, SV2, SV3,

PUMP_O, PUMP_D, PUMP_C, PUMP_S, P_X, making the installation more flexible.

2.1 Function description

1. The hydraulic module board and external kit simultaneously output the open/close of port of TBH, IBH2, IBH1, AHS, SV1, SV2, SV3, PUMP_O, PUMP_D,

PUMP_C, PUMP_S, P_X.

2. The hydraulic module board and external kit are both tested for AD values of port T5, Tbt, T5_2, Tw2, T1, Tsolar. If neither the hydraulic module board nor the external

kit has collected the set active sensor parameters, the hydraulic module board reports a corresponding sensor fault.When the hydraulic module board and the external

kit simultaneously collect different parameter values of the same sensor, the hydraulic module board parameter values shall prevail.

3. Disconnect communication with the main control board for more than 1 minute, the hydraulic module will shut down and output an EL fault, and the fault display on

the wire controller.

4. Connection for other components see the "INSTALLATION AND OWNER'S MANUAL" of indoor unit.