General Safety Precautions - Ferroli EGEA 200 LT User, Installation, And Maintenance Manual

EGEA
200 LT - 260 LT - 200 LT-S - 260 LT-S

1. GENERAL SAFETY PRECAUTIONS

CAUTION:
• This manual is an integral part of the product. Keep it with care with the appliance, and hand it on to
the next user/owner in case of change of property.
• These instructions are also available from the manufacturer's customer service and its website:
www.ferroli.com.
• Read the instructions and warnings in this manual carefully, they contain important information
regarding safe installation, use and maintenance.
Do not use the appliance for any other than its specified use. The manufacturer is not liable for damage resulting from improper or
incorrect use or failure to observe the instructions given in this manual.
This appliance is not intended for use by persons (including children) whose physical, sensory or mental capacities are
reduced, or persons without experience or knowledge, unless they have been given instructions and monitored previously
when using the appliance by a person responsible for their safety.
Children must be supervised to ensure they do not play with the appliance.
This appliance may be used by children 8 years of age or older, and those with reduced physical, sensory or mental capacity
or lack of experience or knowledge, if they are properly supervised or if instructions for the safe use of the appliance have
been given to them and the risks involved are clear to them.
Children are not permitted to play with the appliance.
Water heated to over 50°C can cause immediate serious burns if delivered directly to the taps. Children, disabled persons
and the elderly are particularly at risk. It is recommended to install a thermostatic mixer valve on the water delivery line.
This appliance must not be cleaned or maintained by children without supervision.
Do not touch the appliance when barefoot or if any part of your body is wet.
Do not leave flammable materials in contact with or in the vicinity of the appliance.
The installation of the manual reset thermal circuit breaker supplied with the equipment is required, which interrupts the
power supply to the solar circulator when the intervention temperature of 80 ° C is reached.
The appliance must be emptied when it is out of service in an area subject to subzero temperatures. Drain as described in
the appropriate chapter.
The appliance must be installed and commissioned by a qualified technician in accordance with local legislation and health
and safety regulations. All power circuits must be shut off before you access to the terminal block.
SAFETY WARNINGS
INSTALLATION CAUTION
cod. 3541T600 - Rev. 08 - 12/2021
EN
87