Table of Contents
Advertisement
4 4
Important
The LKP4.6 is installed together with the KP4.6 in a double gang
J box. All knock outs should be removed to provide ventilation.
Do not install the LKP4.6/KP4.6 in a box that also has electrical
installation in it. If installed next to electrical installation either a
barrier-box or two boxes must be used. Also, do not install the
LKP4.6/KP4.6 close to dimmer switches as they generate noise.
Do not install the LKP4.6/KP4.6 where it can be exposed to di-
rect sunlight or strong fluorescent tubes as both can interfere
with IR remote controls. Also, do not install the LKP4.6/KP4.6
close to a plasma TV as they can also interfere with IR remote
controls. A distance of 15 feet (4.5 meter) is safe with most
plasma TV's.
Do not install the LKP4.6/KP4.6 in areas with high humidity or
outdoors.
Do not install the LKP4.6/KP4.6 within line of sight to another
LKP4.6/KP4.6. This could make it difficult to control each zone
separately with a remote control.
Do not install the LKP4.6/KP4.6 within line of sight to the source
equipment. This could interfere with the operation of the source
equipment if receiving IR commands directly and through the
KP4.6.
The LKP4.6/KP4.6 operates on 24V DC supplied through the
CAT5 cable and can therefore often be installed in locations only
permitted for Extra Low Voltage (ELV) equipment. If in doubt,
check the wiring regulation for your application in your area.
Advertisement
Table of Contents
