JAMO LKP4.6 Installation & User Manual page 12

12
Cloning
Step 5.
◄
Press the button on the remote until TRX is flashing.
Step 6.
Start cloning.
Press ENTER on the remote. Display shows SENDING.
Step 7.
Confirm the LKP4.6 is receiving.
RXING will be displayed to indicate it is receiving data.
After approximately 7 minutes the keypad should show
COMPLETE for a few seconds and return to normal op-
eration. If the cloning fails the keypad will show ERROR
or TIMEOUT. Wait until the remote is done sending data
before repeating the process. Make sure cloning cable is
firmly inserted. The cloning must be successful for the
keypad to exit LEARN mode. You can not exit LEARN
mode manually.
Note: See page 18 if keypad is locked in ERROR.