Audi EGRET PRO User Manual page 57

Electric kick scooter
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 48
CAUTION
3. Maintaining the battery
• A kick scooter without any charge must be charged immediately after riding.
Otherwise, an irreparable defect (deep discharge) or greatly reduced service life is
likely. This is not covered by the warranty or guarantee.
• Ideally, charge your scooter indoors in dry conditions and at a moderate ambient
temperature on a fire-resistant, non-conductive surface.
• The power supply unit must first be connected to the electric socket and then to
the kick scooter.
• Do not leave the power supply unit connected to the scooter for more than
24 hours. Otherwise, the electronics or power supply unit may be damaged.
• Do not charge your kick scooter if the charger, the electric socket or the charg-
ing socket are wet.
• As with all other electronic devices, use a surge protector during charging to
protect your kick scooter against damage caused by overloads and voltage peaks.
• Only use the charger supplied by Egret for charging. Do not use a different mod-
el of charger.
• The kick scooter must be at least 50% charged before being stored. Store the
kick scooter at room temperature (22°C) in a dry place away from direct sunlight.
• Charge the scooter at least every 60 days to 50–75% to avoid deep discharge.
Batteries lose charge every day even when they are not used.
Failure to charge the scooter as directed may affect the life of electrical and me-
chanical components, potentially resulting in the failure of such components. This
is not covered by the warranty or guarantee.
Note
4. Inspecting and cleaning the kick scooter
Check and clean your kick scooter after each ride – especially when used for a long time.
This is the only way to detect problems such as loose screws, worn brake pads or worn tyres
in good time.
• In addition, check the frame, fork, folding mechanism, attachment parts and all
moving parts.
• Improper use can lead to sharp edges (e.g. as a result of touching the kerb).
Remove any sharp edges as soon as you notice them.
• Use a soft brush, a slightly damp, soft sponge and a dry cloth to clean your kick
scooter.
57

Advertisement

Table of Contents
loading

Related Products for Audi EGRET PRO

Table of Contents