Download Print this page

Advertisement

Quick Links

BCC-STEELPARK MANUAL

Advertisement

loading
Need help?

Need help?

Do you have a question about the BCC-STEELPARK and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Black Country Customs BCC-STEELPARK

  • Page 1 BCC-STEELPARK MANUAL...
  • Page 2 INTRODUCTION The Black Country Customs range of guitar pedals are born out of the desire to achieve the best guitar tone possible. The result of hours of dedicated testing and listening, each Black Country Customs pedal is built using the highest quality components and engineered to last a lifetime on your board.
  • Page 3 FEATURES Each of the BCC pedals have been designed to incorporate features that really matter :- • Transparent fully buffered operation at all times. • Super high output drive provides an excellent interface between bass guitar and effects pedals/amp. • Much reduced cable loss. •...
  • Page 4 CONTROLS...
  • Page 5 CONTROLS DRIVE Adjust the amount of compression and soft distortion available. BASS Adjusts the low-end content post compression/ distortion. Centre (5) generally flat and a good starting point. Both cut and boost available, allowing players to obtain their desired sound. VOLUME Adjusts the output level to balance sounds or push an amplifier harder into natural distortion.
  • Page 6 CONTROLS...
  • Page 7 CONTROLS TREBLE Adjusts the overall tonal response of the pedal, from smooth and warm all the way to bright and cutting lead tone. FOOTSWITCH Engages the STEELPARK...
  • Page 8: Operation

    OPERATION Install a good quality 9V battery into the pedal by unscrewing the base of the pedal and fitting the battery securely to the battery connector and then replace the base of the pedal. Do not use excessive force to tighten up the 4 base plate screws as this could damage the screws.
  • Page 9: Specifications

    SPECIFICATIONS Model : Boost FX Type : Distortion Input Impedance : 1MΩ Output Impedance : 100Ω Recommended Minimum Load Impedance : 10KΩ Power Supply : Regulated 9V DC PSU (Not In- cluded), centre negative, 2.1x10mm connector type Internal 9V PP3 battery included (alkaline recommended) Current Consumption : 10mA Battery Life : 30 hours –...
  • Page 10 This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference 2) This device must accept any interference received, that may cause undesired operation. Warning: Changes or modification to the equipment not approved by Laney can void the user’s authority to use the equipment.
  • Page 11 NOTES...