Voice Commands - Nokia N92 User Manual

Cell info display—Select
when it is used in a cellular network based on
microcellular network (MCN) technology and to activate
cell info reception.
Enhancement settings.
In the standby mode,
is connected, and
Bluetooth connectivity to a headset is lost.
a compatible loopset is connected.
Select Headset, Loopset, or
from the following:
Default profile—Set the profile that you want activated
each time you connect a certain enhancement to your
device. See 'Profiles—set tones', p. 98.
Automatic answer—Set whether you want the device to
answer an incoming call automatically after 5 seconds. If
the ringing type is set to
answer is disabled.
Lights (for car kit only)—Set whether lights remain on, or
are switched off after the time-out.
116 Copyright © 2006 Nokia. All rights reserved.
On to set the device to indicate
indicates a compatible headset
that the headset is unavailable, or
indicates
Bluetooth handsfree
Beep once or Silent, automatic

Voice commands

You can use voice commands to control your device. For
more information about the enhanced voice commands
supported by your device, see 'Voice dialing', p. 59.
To activate enhanced voice commands for starting
applications and profiles, you must open the
application and its
Tools > Voice cm.
for the applications and profiles. To use enhanced voice
commands, press and hold
and
say a voice command. The voice command is the name of
the application or profile displayed in the list.
To add more applications to the list, select
application. To add a second voice command that can be
used to start the application, select
command, and enter the new voice command as text.
Avoid very short names, abbreviations, and acronyms.
To listen to the synthesized voice tag, select
Playback.
To change voice command settings, select
Settings. To switch off the synthesizer that plays
recognized voice tags and commands in the selected
device language, select
Voice cm.
Profiles folder. Press , and select
> Profiles; the device creates voice tags
in the standby mode, and
Options
Options >
Options
Options
> Off. To reset voice
Synthesiser
> New
Change
>
>