Nokia N92 User Manual page 108

Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change—To prevent line selection (network service),
select Disable if supported by your SIM card. To change
this setting, you need the PIN2 code.
Connection
Data connections and access points
Your device supports packet data connections (network
service), such as GPRS in the GSM network. When you use
your device in GSM and UMTS networks, multiple data
connections can be active at the same time, and access
points can share a data connection. In the UMTS network,
data connections remain active during voice calls.
You can also use a wireless LAN data connection. See
'Wireless LAN', p. 89. Only one connection in one wireless
LAN can be active at a time.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
108 Copyright © 2006 Nokia. All rights reserved.
• Internet access point (IAP) to send and receive e-mail
and connect to the Internet
Check the type of access point you need with your service
provider for the service you want to access. For availability
and subscription to packet data connection services,
contact your network operator or service provider.
Access points
You may receive access point settings in a message from a
service provider. See 'Data and settings', p. 47. Some or all
access points may be preset for your device by your service
provider or network operator, and you may not be able to
change, create, edit, or remove them.
protected access point.
indicates a packet data access point, and
wireless LAN access point.
Tip! To create an Internet access point in a wireless
LAN, press , and select
Availab. WLAN > Options
To create a new access point, select
point. Select Use default settings
access point settings, or Use existing settings
existing access point as the basis for the new access point..
To edit the settings of an access point, select
Edit. Follow the instructions from your service provider
indicates a
a
Connect. > Conn. mgr. >
> Define access point.
Options > New access
to use the default
to select an
Options >