Fueling Instructions - Stihl FS 361 C-M Owner's Instruction Manual

5 IMPORTANT SAFETY INSTRUCTIONS
￭ Genuine STIHL replacement parts are specifically
designed to match your power tool and meet safety and
performance requirements. Use of parts that are not
authorized or approved by STIHL may cause serious or
fatal injury or property damage.
– STIHL recommends that only identical STIHL
replacement parts be used.
5.6

Fueling Instructions

Fuel
WARNING
￭ Gasoline and its vapors are extremely flammable. Your
STIHL trimmer / brushcutter uses an oil-gasoline mixture
for fuel. If spilled and ignited by a spark or other ignition
source, it can cause fire and serious burn injury or
property damage.
– Use extreme caution when handling
gasoline or fuel mix.
– Do not smoke or bring any fire or flame
near the fuel or the trimmer / brushcutter.
– Note that combustible fuel vapor may
escape from the fuel system.
Pick a Safe Location for Fueling
WARNING
￭ To reduce the risk of fire and explosion while fueling:
0458-838-8601-A
– Always place the power tool on the
ground before attempting to fuel the
machine.
– Fuel your trimmer / brushcutter in a well-
ventilated area, outdoors away from
flames, pilot lights, heaters, electric
motors, and other sources of ignition.
Vapors can be ignited by a spark or
flame many feet away.
– Select bare ground for fueling and move
at least 10 ft. (3 m) from the fueling spot
before starting the engine.
– Wipe off any spilled fuel before starting
your trimmer / brushcutter.
– Take care not to get fuel on your
clothing. If this happens, change your
clothing immediately.
Allow the Engine to Cool Before Removing the Fuel Cap
WARNING
￭ Gasoline vapor pressure may build up inside the fuel tank.
The amount of pressure depends on a number of factors,
such as the fuel used, altitude, and temperature. To
reduce the risk of burns and other personal injury from
escaping gas, vapor and fumes:
– Always shut off the engine and allow it to cool before
removing the fuel cap.
￭ The engine is air cooled. When it is shut off, cooling air is
no longer drawn across the cylinder and engine
temperatures will rise for several minutes before starting
to cool. In hot environments, cooling will take longer. To
reduce the risk of burns and other personal injury from
escaping gas vapor and fumes:
– Allow the trimmer / brushcutter to cool. If you need
to refuel before completing a job, turn off the
machine and allow the engine to cool before opening
the fuel tank.
English
11