Aiwa AM-F90 Service Manual page 42

ELECTRICAL ADJUSTMENT-11/11
61. Press the "VOL +" key (adjustment value increases) and/or the
"VOL –" key (adjustment value decreases) so that the
adjustment value becomes F8.
Display on remote control LCD
: Adjustment value
62. Press the ";" key.
(The 0D74 segments flash.)
63. Press the "VOL +" key once and change the value of the
flashing segments to 0D75.
Display on remote control LCD
: Adjustment value
64. Press the "9" key.
(The 00 segments flash.)
65. Press the "VOL +" key (adjustment value increases) and/or the
"VOL –" key (adjustment value decreases) so that the
adjustment value becomes 1C.
Display on remote control LCD
: Adjustment value
66. Press the ";" key.
(The 0D75 segments flash.)
67. Press the "VOL +" key once and change the value of the
flashing segments to 0D76.
Display on remote control LCD
: Adjustment value
68. Press the "9" key.
(The 00 segments flash.)
69. Press the "VOL +" key (adjustment value increases) and/or the
"VOL –" key (adjustment value decreases) so that the
adjustment value becomes 03.
Display on remote control LCD
: Adjustment value
70. Press the ";" key.
(The 0D76 segments flash.)
71. Press the "VOL +" key and change the value of the flashing
segments to 0D78.
Display on remote control LCD
: Adjustment value
72. Press the "9" key.
(The 00 segments flash.)
73. Press the "VOL +" key (adjustment value increases) and/or the
"VOL –" key (adjustment value dcreases) so that the
adjustment value becomes 01.
Display on remote control LCD
: Adjustment value
74. Press the ";" key.
(The 0D78 segments flash.)
75. Press the "VOL +" key once and change the value of the
flashing segments to 0D79.
Display on remote control LCD
: Adjustment value
76. Press the "9" key.
(The 00 segments flash.)
77. Press the "VOL +" key (adjustment value increases) and/or the
"VOL –" key (adjustment value dcreases) so that the
adjustment value becomes E0.
Display on remote control LCD
: Adjustment value
78. Press the ";" key.
(The 0D79 segments flash.)
79. Keep pressing the "DISPLAY" key of remote control for
several seconds (approx. 3 seconds) in order to exit the patch
data write mode.
(The machine returns to the MANUAL Mode display of the
test mode.)
Display on remote control LCD
: Adjustment value
80. Press the ";" key in order to write the modification data in
memory.
(The adjustment value changes to CC.)
81. When the adjustment value changes to DD, it indicates that
writing the modification data ends with success.
Display on remote control LCD
: Adjustment value
82. Turn off the power.
-42-