Table of Contents
Advertisement
2. The SIO2USB Device
2.1.
Connectors
On the right side of the device case is a SIO interconnection cable fixed.
On the left side of the device case is a USB connector fixed to plug in a USB
Flash drive (power consumption max. 100mA).
2.2.
Indicators and Display
On the upper left side of the SIO2USB-Interface four LEDs are installed.
• POWER: the most upper LED lights up green when the device is powered
via the SIO bus.
• ERROR: the second LED from top lights up red when a error occures. See
the error codes in chapter 8.
• MEMORY: the third LED from top flashes yellow when read or write access
to the USB Flash drive or internal memory is performed.
• SIO: the fourth LED from top flashes yellow when data are transfered on the
SIO bus.
In the middle of the SIO2USB device is a Liquid Crystal Display (LCD) with
four lines installed (in the following named display). The menu or the installed
virtual disks and the functionality of the keys are shown there.
2.3.
Keys
Directly right to the display are five keys installed. The function of the upper
four keys depends on the displayed menu. Below them is another shorter key
installed to reset the SIO2USB-Interface.
2.4.
Internal Memory
Within the SIO2USB an internal memory is installed, that is permanently a-
vailable. How to access and operate the internal memory is described in the
chapters 4 and 5. Access to this memory is always possible even when no
USB Flash drive is connected.
SIO2USB User Manual
Chapter 2 The SIO2USB Device
7
Advertisement
Table of Contents
