Table of Contents
Advertisement
3. Connecting the Interface
3.1.
Connecting the SIO2USB to the Computer
1. Switch off the computer.
2. Connect the SIO cable of the SIO2USB to the computer. It is possible to
connect the SIO cable to any free SIO connector of a disk station which is
connected to a computer.
3. Insert the USB-Stick ("USB mass storage") into the connector on the left
hand side of the SIO2USB interface.
4. Power on the computer. LED 1 "Power" should light up green and the dis-
play on the SIO2USB should show the time and date, alternatingly.
3.2.
Connecting an USB-Stick to the SIO2USB
Inserting an USB stick is possible while the system is powered on (hot plug-
ging). In some cases this could cause a reset/restart in the SIO2USB. The
ATARI™ computer is not affected by this.
SIO2USB User Manual
Chapter 3 Connecting the Interface 11
Advertisement
Table of Contents
Need help?
Do you have a question about the SIO2USB and is the answer not in the manual?
Questions and answers