Advertisement
IMPORTANT: If the brushbar has been obstructed, the Motor Protection Sensor may have been activated and the
brushbar will stop. Remove the floor head from the machine and clear any obstruction. Refit the floor head, switch
on the vacuum cleaner by pressing the trigger.
Removing and replacing the multi-surface floor head brushbar
Switch off the vacuum
and press the Floor
Head Release Button to
detach the floor head
from the wand. Slide
and hold the brushbar
release button with
one hand, using the
other hand remove the
brushbar from the floor
head.
Removing and replacing the mini motorised tool brushbar
Remove the mini
motorised tool from the
vacuum. Slide and hold
the brushbar release
button with one hand,
using the other hand
remove the brushbar.
Taking care of your machine
Using scissors, carefully
remove any threads or
hair from around the
brushbar and clear any
dirt or debris from the
floor head. Avoid
damaging or cutting the
bristles.
Using scissors, carefully
remove any threads or
hair from around the
brushbar and clear any
dirt or debris from the
floor head. Avoid
damaging or cutting the
bristles.
When re-fitting the
brushbar fit the right side
into the housing first.
Then line up and slot into
place the left side.
When re-fitting the
brushbar fit the right
side into the housing
first. Then line up and
slot into place the left
side.
IMPORTANT:
For best performance,
regularly remove any
threads or hair from
around the brushbar.
IMPORTANT:
For best performance,
regularly remove any
threads or hair from
around the brushbar.
Advertisement
