Advertisement
Getting started
Installing the wall mount
NOTE: The wall mount should be installed near a power supply where the charger cord can extend from the vacuum
down to the plug in the wall.
IMPORTANT: The wall mount is not designed to hold the full weight of the vacuum. The floor head should be
positioned flat on the surface of the floor to support the weight of the vacuum while the wall mount positions the
vacuum in the upright position.
Fully assemble the
vacuum and attach the
wall mount into the
handle. With the wall
mount attached, stand the
vacuum close to the wall,
in the upright position
with the floor head flat on
the floor.
Holding the wall bracket
firmly in place, carefully
remove the vacuum.
Using a pencil make
a small mark for each
screw. Use both screws
and wall plugs to secure
the wall bracket to the
wall.
The accessories can also be
stored on the wall mount.
Advertisement
