Coupling The Lcc Enclosure And Bracket To The Mounting Plate - 1 Sound Tower Series Installation Manual

TOWER SYSTEM LCC44/LCC84 WALL INSTALLATION
Figure 23. Driving the screw anchors into the wall.
• While holding the plate in place, use a socket wrench or a power
screwdriver to tighten each fastener gradually, alternating
diagonally opposed fasteners in an "X" pattern until each holds
the plate to the wall. When using a power driver, keep it at a
low speed to avoid stripping the threading cut into the substrate
material. Once the washer or flanged head on each bolt is in
contact with the plate and the plate is against the wall, continue
tightening them only by hand.
Figure 24. Tightening the screw anchors with a
torque wrench.
• Using a torque wrench, tighten each screw anchor into the
wall. Take care not to exceed the maximum installation torque
specified by the manufacturer of the hardware.
Figure 25. Applying downward force to verify the
mount.
• Apply force or weight to the mounting plate to physically verify
its ability to support the necessary load. There must be no
movement possible between the plate and the wall.
Coupling the LCC enclosure and bracket to the mounting
plate
Once the mounting bracket has been installed on the LCC84 or LCC44
and the mounting plate has been secured to the mounting surface, the
speaker enclosure can be mounted on the wall.
Figure 26. Installing the LCC44 with the bracket
onto the mounting plate.