8.
Click Update. The Update and Configure Unit dialog box will come into view, as Figure 2 shows.
Note the instructions in the dialog box.
9. Click Configure.
10. Within 5 seconds of clicking configure, turn on the power supply.
11. When the program establishes the connection with the SI-2, the Establishing Connection message will
appear in the dialog box, as Figure 3 shows.
If the program times out before you turn on the power supply, the No Unit Detected dialog box (Figure 4)
appears.
Figure 4 No Unit Detected appears when the program times out before you turn on the power supply.
If "No Unit Detected" occurs, you need to turn off the power supply and click OK. Then repeat the
start-up process, by clicking Configure in the Update and Configure Unit dialog box.
Figure 2 Click Configure in the Update and Configure Unit dialog box.
Figure 3 Establishing connection with the SI-2
53