Cameo X3 TW User Manual page 16

TIMER FUNCTION
The timer function allows timed control of the Direct and CCT stand-alone modes in such a way
that the fade-in time (Fade In) can be set from 1 to 60 minutes, the dwell time (Dwell Time) from
1 to 24 hours and the fade-out time (Fade Out) from 1 to 60 minutes. Time control starts immedi-
ately after activating the timer function in the previously activated standalone mode and remains
active even if the spotlight is switched off and restarted.
Starting from the main display, press the encoder to enter the main menu. Select the Stand Alo-
ne menu item, confirm, then select Timer and confirm again. Now select Fade In, Dwell Time
or Fade Out for the individual settings and confirm. The display shows a number field in each
case and you can set the value as desired from 1 to 60 or 1 to 24 by turning the encoder. Confirm
again. Once all settings have been made as desired, activate the timer function by selecting the
Timer On/Off sub-menu item, confirm, select On and confirm again (to deactivate the timer func-
tion, please select Off and confirm).
Note: The timer function is suitable for use in master/slave operation via cable.
SLAVE MODE
Starting from the main display, press the encoder to enter the main menu. Select the Slave
menu item and confirm the selection. Connect the slave and the master unit (same model, same
software version) using a DMX cable and activate one of the stand-alone operating modes (Direct,
CCT) in the master unit. The slave unit will now follow the master unit.
16