Cameo X3 TW User Manual page 15

CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press the encoder to enter the main menu. Now select the menu
item DMX Mode and confirm. Select the desired DMX operating mode and confirm the selection.
Tables with the channel assignments can be found in these instructions under DMX CONTROL.
STAND-ALONE DIRECT MODE
The stand-alone Direct mode allows dimmer, strobe, warm white and cold white to be set directly
on the unit, similar to a DMX controller. In this way, an individual scene can be created without an
additional DMX controller.
Starting from the main display, press the encoder to enter the main menu. Now select the Stand
Alone menu item, confirm, then select Direct and confirm again. Now select the menu item you
wish to edit and confirm. Set the desired value and confirm the entry. The values for the strobe
effect correspond to the values in channel 3 of the DMX table 7 CH 16 bit.
CCT STANDALONE MODE (Correlated Colour Temperature)
Adjust the dimmer, strobe and colour temperature as desired.
Starting from the main display, press the encoder to enter the main menu. Now select the Stand
Alone menu item, confirm, then select CCT and confirm again. Now select the menu item you
wish to edit and confirm. Set the desired value and confirm the entry. The values for the strobe
effect correspond to the values in channel 3 of the DMX table 7 CH 16 bit.
15