Troubleshooting - Maretron WSO200 User Manual

WSO200 User's Manual

5 Troubleshooting

If you notice unexpected operation of the Maretron WSO200, follow the troubleshooting
procedures in this section to remedy simple problems.
Symptom
No data output
Incorrect wind direction or speed
Incorrect humidity reading
If these steps do not solve your problem, please contact Maretron Technical Support (refer to
Section 7 for contact information).
Warning: There are no user-serviceable components inside the Maretron WSO200. Opening
the WSO200 will expose the sensitive electronic components to adverse environmental
conditions that may render the unit inoperative. Please do not open the WSO200, as this will
automatically void the warranty. If service is required, please return the unit to an authorized
Maretron service location.
Page 10
Troubleshooting Procedure
Check the connections to the NMEA
®
2000 connector and tighten if
necessary
Ensure that power is supplied to the
connected NMEA 2000
Ensure that the flow of wind into the
WSO200 is not blocked by surrounding
structures.
Ensure that the flow of wind through
the WSO200 is unimpeded and that the
unit is free of debris.
Check that a humidity offset value has
not been configured
Replace the humidity sensor
®
cable
Revision 1.0