Table of Contents
Advertisement
WSO100 User's Manual
4 Maintenance
Regular maintenance is important to ensure continued proper operation of the Maretron
WSO100. Perform the following tasks periodically:
• Clean the unit with a soft cloth. Do not use chemical cleaners as they may remove
paint or markings or may corrode the WSO100 enclosure or seals. Do not use any
cleaners containing acetone, as they will deteriorate the plastic enclosure. Any spider
webs, etc. that accumulate inside the open portion of the WSO100 may be cleaned out
with a water spray.
• Ensure that the unit is mounted securely and cannot be moved relative to the mounting
surface. If the unit is loose, tighten the mounting screws.
• Check the security of the cable connected to the NMEA 2000
necessary.
5 Troubleshooting
If you notice unexpected operation of the Maretron WSO100, follow the troubleshooting
procedures in this section to remedy simple problems.
Symptom
No data output
Incorrect wind direction or speed
If these steps do not solve your problem, please contact Maretron Technical Support (refer to
Section 7 for contact information).
Warning: There are no user-serviceable components inside the Maretron WSO100. Opening
the WSO100 will expose the sensitive electronic components to adverse environmental
conditions that may render the unit inoperative. Please do not open the WSO100, as this will
automatically void the warranty. If service is required, please return the unit to an authorized
Maretron service location.
Page 8
Troubleshooting Procedure
Check the connections to the NMEA
®
2000
connector and tighten if
necessary
Ensure that power is supplied to the
connected NMEA 2000
Ensure that the flow of wind into the
WSO100 is not blocked by surrounding
structures.
Ensure that the flow of wind through
the WSO100 is unimpeded and that the
unit is free of debris.
®
interface and tighten if
®
cable
Revision 1.2
Advertisement
Table of Contents
