Table of Contents
Advertisement
WSO200 User's Manual
2.5.6 Outside Temperature Offset Calibration
If you wish to apply an offset to the temperature reported by the WSO200, you may change the
temperature to match the value you wish displayed, which will create and apply an offset to
future temperature readings.
2.5.7 Advanced Configuration...
Certain parameters do not normally need to be set for normal operation but are included in an
advanced configuration section for use in special situations.
2.5.7.1 Device Instance Configuration
This entry allows you to program the NMEA 2000 device instance for the unit. You usually will
not need to modify the default value of "0" unless you have multiple units on the network.
Device instance is always used in the Wind PGNs.
2.5.7.2 Instance – Humidity Configuration
This entry allows you to program the NMEA 2000 device instance for the humidity transmitted
in PGN 130313. You usually will not need to modify the default value of "0" unless you have
multiple humidity sensors on the network.
2.5.7.3 Instance – Pressure Configuration
This entry allows you to program the NMEA 2000 device instance for the air pressure
transmitted in PGN 130314. You usually will not need to modify the default value of "0" unless
you have multiple pressure sensors on the network.
2.5.7.4 Instance – Temperature Configuration
This entry allows you to program the NMEA 2000 device instance for the temperature
transmitted in PGN 130312. You usually will not need to modify the default value of "0" unless
you have multiple temperature sensors on the network. Note that the TMP100 module also
generates these PGNs.
2.5.7.5 Installation Description Configuration
The WSO200, along with all other certified NMEA 2000 devices, has two user-programmable
installation description fields. You may program these fields with information specific to the
device, such as date installed, the initials/name of the installer, the physical location of the
device, etc. This configuration option will allow you to program the values of these fields.
2.5.7.6 NMEA 2000 PGN Enable/Disable Configuration
®
The WSO200 is capable of transmitting NMEA 2000
messages. You may individually enable
or disable each of these messages. You may also change the rate of transmission of each of
these messages if desired.
2.5.7.7 Restore Factory Defaults
Selecting this configuration option causes all stored parameters in the WSO200 to be reset to
the values they contained when the unit was manufactured.
Page 6
Revision 1.0
Advertisement
Table of Contents
