Service Tools - Sony SAL55200-2 Service Manual

NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, don't pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, don't press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case of the following notches or holes are located in the lens block, etc during disassembling/
assembling the lens, Use the universal wrench.
Notches
How to Use
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes: chip-B
Match the universal wrench to the holes or notches of the lens block, etc.
Match the universal wrench
to the width of holes or notches.
Fixed screw
Chip

SERVICE TOOLS

B-10 Adhesive bond (B-10):
LOCTITE 460
or the equivalent
SAL55200-2 (DT 4-5.6/55-200 SAM) (DT 55-200mm F4-5.6 SAM)
Universal wrench
J-6082-609-A
Chip
Fixed screw
J-6082-612-A
Adhesive bond (LOCTITE 460)
or the equivalent.
2. DISASSEMBLY
Holes
Chip-A for
universal wrench:
J-6082-609-1
Chip-A
Universal wrench
Chip-B
G-22
Grease (G-22):
G-32
Grease (G-32):
G-36
Grease (G-36):
2-1
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Chip-B for
universal wrench:
J-6082-609-2
Chip-A
Notches
Chip-B
Holes
J-6082-665-A
J-6082-666-A
J-6082-667-A