Adjust Parking Brake; Replace Pto Belt - Gravely Pro-Walk 36 Operator's Manual

ADJUST PARKING BRAKE

If parking brake lever does not engage
parking brake shaft, brake cable may need
adjustment.
1. Remove five tapping screws from each
dashboard side panel and remove
panels. Retain all parts for reinstallation.
See Figure 29.
Figure 29
2. Disengage parking brake.
See Figure 30.
3. Loosen upper jam nut and tighten the
lower jam nut until tight against cable
bracket.
4. Reposition rubber boot against
adjustment barrel.
5. Check cable adjustment and readjust as
necessary.
1. Upper Jam Nut
2. Lower Jam Nut
3. Rubber Boot
Figure 30
6. Reinstall side panels using original
hardware.
3
1
2

REPLACE PTO BELT

CAUTION: Damaged or worn
belts may result in injury and / or
damage to the unit. Check belts
for excessive wear or cracks
often.
Remove PTO Belt
See Figure 31.
1. Place unit in service position. See
Service Position on page 19.
2. Position mower deck at lowest cutting
height. See Set Cutting Height on
page 16.
3. Lift belt covers to remove from mower
deck.
4. Remove wing knobs retaining belt access
cover and remove cover.
CAUTION: Use care when
releasing idler spring tension.
Keep body parts away from
idlers when performing this
operation.
See Figures 32 and 33.
5. Slowly remove spring hook from anchor
bolt to release belt idler tension.
6. Remove hardware retaining support
bracket to idler and remove bracket.
EN - 27
Figure 31