Advertisement
2) Assigning the receiver module to the MD3300MRP load manager
▶ When the Radio Bus has been created, assign the MTR receiver module
which pilots the load to the MD3300MRP load manager following the
procedure described in paragraph "Radio assignment between an MTR
receiver module and the MD3300MRP load manager".
After performing the RADIO assignment between the receiver modules
10. CHANNEL CONFIGURATION MENU (PRIORITY)
New assignment
ASSIGNING AN MTR RECEIVER MODULE TO A CHANNEL
▶ On the MD3300MRP load manager, access the PARAMETER configuration
menu by pressing the key
flashing.
▶ Press the arrow key
or
display. Press the
key to enter the CHANNEL configuration menu.
▶ The device display shows "Add CH". Press the
receiver module to the channel.
▶ The display shows "CH N. .8" where the parameter "N" indicates the
channel number (from 1 to 8) where the assignment to the receiver module
is made, the parameter 8 indicates the maximum number of channels.
It is recommended to perform the assignment starting with the
channels with the highest priority.
DS1054-074B
PARAMETER CONFIGURATION MENU
Setpoint
0,8÷7 Kw
10÷9999 s
CHANNEL CONFIGURATION MENU
Assignment removal
CH N ÷ 8
. The icons
/
and "kW" will start
until the icons
and
key to assign the
and the MD3300MRP load manager, it is necessary to make the assignment
between the receiver modules and the device channels, so as to indicate to
the MD3300MRP load manager which receiver modules are to be piloted
according to the priorities.
The MD3300MRP device is able to manage up to 8 channels, each with
a different priority: channel 1 = priority 1 = highest priority.
Ton
10÷9999 s
Test
CH N ÷ 8
▶ Press the arrow keys
to perform the assignment. Press the key
▶ While "InProG" is flashing for 30 seconds, press briefly with a sharp, properly
insulated tool into the "Connect" hole on the receiver module.
flash on the
▶ The MD3300MRP device will briefly display the message "PASS" if the
assignment of the channel to the receiver module has been successful.
▶ If the device displays the message "Err. 03" the assignment has not been
successful. Repeat the operation and make sure to press into the "Connect"
hole on the receiver module within the 30 seconds in which the MD3300MRP
load manager displays the message "InProG".
▶ It is necessary to repeat the procedure for each receiver module you wish to
assign to a channel of the MD3300MRP device.
It is possible to assign more than one receiver module to each channel.
In this case, if the absorption threshold is exceeded, there will be two
or more loads disconnecting at the same time.
Channel con guration menu
Procedure completed
Procedure failed
or
to select the channel "N" on which you want
to confirm.
>2 sec.
>2 sec.
Advertisement
