Advertisement
•
I have excellent signal strength, but I cannot see my
network.
WEP is probably enabled on the Access Point, but not on your
wireless adapter (or vice versa). Verify that the same WEP Keys and
levels (64, 128 or 152) are being used on all nodes on your wireless
network.
•
How do I avoid interference?
Using multiple Access Points on the same channel and in close
proximity to one another will generate interference. When
employing multiple Access Points, be sure to operate each one on a
different channel (frequency).
•
How do I reset the Access Point?
Press the Reset button on the back of the Access Point for about
ten seconds. This will reset the unit to its default settings.
© 2003 Cisco Systems, Inc. All Rights Reserved.
Troubleshooting
Slide 55
Model No:WAP55AG
Advertisement
Troubleshooting
