Table of Contents
Advertisement
Signal LED
A green and a red LED are integrated in the housing, above the emergency stop
button. The LEDs are user-defined and can be controlled in via AS-I Bus.
Home position sensor
This function provides information as to whether the three-position device is in its holder.
The home position sensor delivers a signal, transmitted via AS-I Bus when HD5 is in place in the
active holder (HD5-M-001). The holder is available as an accessory.
Attention!
This signal is not failsafe and must not be used for a safety function.
Assist Light
The assist Light is in the front of the HD5 and can be used for short
periods when the ambient light is insufficient.
Controll of the function via AS-I Bus.
Note on duty cycle
For ambient temperatures ≤ 35°C, the flashlight should never be used longer than 15 min at a time and
max 60% on-time
For ambient temperatures over 35°C, the flashlight should never be user more than 10 min at a time and
max 40% on-time
On-time percentage = [on time/ (on time + off time)] x 100
Caution
The increased heat can damage the device. Make sure to comply to the above requirements.
If the device had stopped working because of temperature rise, it will work again once the values have
dropped below the limits. However, there may still be damage to the electronics and a reduction in product
lifetime.
Attention! Hazards arising from glare
Avoid looking directly into the lens of the assist light. Looking directly into the lens, and the glare effect
which may result from it, can sometimes impair vision, cause irritation, and result in accidents.
14
Advertisement
Table of Contents
