Table of Contents
Advertisement
Setup Menus
Video Inputs
If desired, you can assign a video source to each of the "audio only" inputs.
The default for each of these settings is "None". This is a great way to listen
to the ball game over the Internet Radio and watch it over your normal video
display device, though timing might be a little off.
HDMI Settings
X/XR Series Processors and Receivers feature very powerful video processing.
Video settings should be selected carefully to optimize your video
performance.
Zone 1 OSD - This selects the pop-up text messages to be On or Off.
Zone 1 Out - Set the output for Zone 1 from either Output 1 (Main), Output 2
(Alt), or both.
Lipsync (Information Only) - When this feature is supported by the display
device, this setting displays how much lip sync is applied to HDMI Outputs.
HDMI Audio to TV - Use this to set audio to be sent to the TV.
HDMI Bypass & IP - Sets the state of IP control and HDMI bypass of the unit
while in Standby. When in Low Power mode, network or IP control and HDMI
bypass are disabled. With HDMI & IP On, the unit will respond to IP control
when in standby and HDMI bypass is enabled.
HDMI Bypass Source - Specifies the source used when HDMI bypass is on.
Specific inputs can be specified or the last input used.
CEC Control - Enables/disables CEC control.
eARC Control - Enables/disables automatic volume control from the display.
TV Audio - Enables/disables auto-switching to eARC audio from the display.
Power Off Control - Enables/disables automatic power control from other CEC
devices.
X/XR Series Processors & Receivers
28
When On, any adjustments made on the unit (like volume, mute state
changes, sub trim level) will be shown on your display screen, as well as
on the unit's front panel display.
When Off, any adjustments will only be shown in the unit's front panel
display. This leaves your screen clear from interruption.
Advertisement
Table of Contents
