Table of Contents
Advertisement
Setup Menus
Input Configuration
Each input has individual audio and video settings that can be adjusted
specifically for its use.
Input - Identifies the currently selected source. Settings are displayed below.
Name - Specific name/label for this input that will show on the front display
and the OSD. The name can be changed, and this is very useful when
more than one source unit has similar functions (for example, two Satellite
processors could be named SAT1 and SAT2).
Lip Sync - Many video processors and line multipliers cause a slight delay
between the sound and the video picture. Highly compressed video signals
such as MPEG encoded satellite processors and some DVDs also suffer from
this problem. The Lip Sync setting delays the audio a small amount to allow
the video image to catch up. If this is an audio only input - like Aux, then
LipSync is grayed out.
Mode - Sets the initial audio decode mode for stereo sources on this input.
MCH. Mode - Sets the initial audio decode mode for multi-channel digital
sources on this input.
Bass and Treble - Changes the bass and treble response for all speakers when
using this input. Very useful when you have a source unit that has reduced
frequency response due to the format (i.e. older VCRs or 8-Tracks)
Room EQ - When the Dirac Live application is run and EQ filters are
Downloaded into one of the three slots available, this can be selected.
Input Trim - Selects the maximum analog signal for this input before clipping.
This setting should match the audio output of your source units with the
available settings being 1, 2, and 4 volts RMS and the default being 2 volts.
Source units with low output levels can benefit from being set to higher output
settings such as 1 V or 2 V.
X/XR Series Processors & Receivers
22
Last Mode - recalls the last used setting for stereo sources. See section
"Surround Modes" on page 29 for more information.
Last Mode - recalls the last used setting for multi-channel sources. See
section "Surround Modes" on page 29 for more information.
Not Calculated - (Information only) There are no EQ filters, so cannot be
selected.
Project Name - Dirac Live Room EQ is applied to the current source and
will display the name of the project from the Dirac Live application.
Off - Dirac Live Room EQ is not applied to the current source.
Advertisement
Table of Contents
