RGMT BATTLEDRESS - Chronograph Watch Manual

OVERVIEW

HOW TO CHANGE THE STRAPS TO NATO STRAP

PLEASE READ THE FOLLOWING BEFORE UNSCREWING THE CROWN:
SCREW-DOWN CROWN
Screw-down crowns are used to ensure water resistance. ALWAYS be certain that your crown is securely screwed down ( Position [0] is secured. Positions [1], [2] and [3] are not secured for water resistance ).
Do NOT unscrew your crown while you are in any environment where moisture is present.

USING THE SCREW-DOWN CROWN

DO NOT PULL THE CROWN UNLESS IT IS UNSCREWED FIRST:
TO UNSCREW: Turn the crown anti-clockwise until it turns freely without tension. GENTLY pull the crown out to the other desired positions for watch setting (see specific operating instructions on the following pages).

TO SCREW: Push the crown ALL THE WAY IN (towards the watch) THEN begin to turn clockwise until it is securely screwed down.

NOTE: Failure to SECURELY screw down the crown after setting the watch may affect its water resistance.

HOW TO SET THE TIME

HOW TO SET THE DATE

Please note: The date can be changed during the date changing phase between approx. 9:00 PM and 12:00 PM; please note that the date must be set to the date of the following day as in this case the automatic date changing does not occur at midnight.

STOPWATCH FUNCTION

• The stopwatch measures up to 10 hours.

STANDARD MEASUREMENT

ACCUMULATED ELAPSED TIME MEASUREMENT

Restart and stop of the stopwatch can be repeated by pressing the button A.

SPLIT TIME MEASUREMENT

Measurement and release of split time can be repeated as many times as necessary by pressing the button B.

ADJUST THE CHRONOGRAPH HANDS TO ZERO POSITION

Example:
One or several chronograph hands are not in their correct zero positions and have to be adjusted (e.g. following a battery change).

1. Unscrew and pull out the crown to position [3]-(2nd click). (all chronograph hands are in their correct or incorrect zero position).
   
   
2. Keep push-buttons A and B depressed simultaneously for at least 2 seconds (the second counter hand rotates by 360º corrective mode is activated).
   
   
3. Adjusting the second counter hand: Single step, push button A once
   Continuous. push & hold button A long
   
   To adjusting the next hand push button B
   
   
4. Adjusting the minute counter hand (position 9h):
   Single step, push button A once
   Continuous. Push & hold button A long
   
   Push the crown back and screw down in the position[0] to terminate the chronograph hands adjustment.
   

WATER RESISTANCE

Note that the water resistance chart serves only as a guide (please refer to the water resistance chart on the next page). Actual water resistance may vary depending on a number of factors including water temperature, water salinity, and use under water.
The water resistance of your timepiece may eventually be compromised over time with general wear and tear and use of your timepiece under adverse conditions.
Always remember to employ the screw down crown if available to maintain the water resistance of your timepiece. Warranty may be voided if the screw down crown has not been properly employed.
Note that you should never wear your watch in a jacuzzi or steam room where steam may enter the case despite the water tight seals used to protect your watch. This may cause condensation inside your watch which may effect and damage the inner workings of your watch.

WATER RESISTANCE CHART	100M/ 10ATM
SPLASH / SHOWERING
SWIMMING / BATHING
BRIEF SWIMMING / WATER SPORTS
PROLONGED SWIMMING / FREE DIVING
SCUBA DIVING
PROFESSIONAL DEEP SEA DIVIN G

This timepiece is equipped with a SWISS MADE CHRONOGRAPH movement.

For more details on operating this timepiece please refer to the enclosed booklet or visit: IM.RGMT.CO